Re: [ULF-1] Gluing surface preparation

From: Member 121
Date: 2018-06-10 15:19 UTC-07:00
Message: #0595

Epoxy can be stapled to hold parts . But removing staples is a good idea
when its cured or dry so the don't stain the Member 60

On Sun, Jun 10, 2018, 2:58 PM Member 111 <[email]>
wrote:

> Member 67 et al,
>
> Did you use a fine toothing plane to rough up all spruce and ply at the
> bonding areas? Could you describe your method of shaping parts with complex
> geometries like spar caps? Did you use a series of planes? Would you mind
> sharing what brand, type, and methodologies of cutting and sharpening them
> if so? Also for inspection, was a simple scale used to measure cap height
> and width or were calipers and more precise methods used? Thanks again for
> being so active and forthcoming with details about your great project.
>
> Austin
> _______________________________________________
> ULF-1 discussion list -- [email]
>
> Subscribe, Unsubscribe, Preferences, List information:
> http://lists.ulf-1.com/listinfo.cgi/ulf-1-ulf-1.com
>